2014-10-28T22:24:31.427Z,1414535071.427 [SBIT](CRITICAL): SBIT FAILED
2014-10-28T22:23:10.736Z,1414534990.736 [Supervisor](FAULT): Ignoring configuration overrides from Data/persisted.cfg
2014-10-28T22:23:21.347Z,1414535001.347 [SBIT](IMPORTANT): Tethys CM Info: SVN revision:11797
2014-10-28T22:23:21.347Z,1414535001.347 [SBIT](IMPORTANT): Kernel Release: 2.6.27.8
2014-10-28T22:23:21.347Z,1414535001.347 [SBIT](IMPORTANT): Kernel Version:#639 PREEMPT Wed Mar 12 12:53:33 PDT 2014
2014-10-28T22:23:21.349Z,1414535001.349 [CBIT](FAULT): LAST RESTART WAS UNINTENTIONAL.
2014-10-28T22:23:23.105Z,1414535003.105 [g3ESP](FAULT): LCB fault:  Software Overcurrent.
2014-10-28T22:23:37.261Z,1414535017.261 [SBIT](IMPORTANT): Beginning Startup BIT
2014-10-28T22:23:37.264Z,1414535017.264 [CBIT](IMPORTANT): Beginning GF scan
2014-10-28T22:23:42.285Z,1414535022.285 [AcousticModem_Benthos_ATM900](FAULT): failed to initialize, no bytes available on serial interface
2014-10-28T22:23:50.495Z,1414535030.495 [SBIT](FAULT): Rudder: EXPECTED:15.000000 ACTUAL:14.667913
2014-10-28T22:24:04.445Z,1414535044.445 [CBIT](IMPORTANT): No ground fault detected
2014-10-28T22:24:06.522Z,1414535046.522 [AcousticModem_Benthos_ATM900](FAULT): failed to initialize, no bytes available on serial interface
2014-10-28T22:24:30.428Z,1414535070.428 [AcousticModem_Benthos_ATM900](FAULT): failed to initialize, no bytes available on serial interface
2014-10-28T22:24:31.428Z,1414535071.428 [CommandLine](FAULT): Scheduling is paused
2014-10-28T22:24:31.820Z,1414535071.820 [MissionManager](IMPORTANT): Started mission Startup
2014-10-28T22:24:38.048Z,1414535078.048 [BPC1](FAULT): Failed to receive battery data
2014-10-28T22:24:52.970Z,1414535092.970 [g3ESP](IMPORTANT): STATUS:Sampling up to 1000ml
2014-10-28T22:24:54.609Z,1414535094.609 [AcousticModem_Benthos_ATM900](FAULT): failed to initialize; deviceResponse_ loaded: CONNECT 00800 bits/sec 1 of 4, Rate 1/2 CC 12.50ms MGP
, available: Lowpower

2014-10-28T22:25:02.183Z,1414535102.183 [AcousticModem_Benthos_ATM900](FAULT): invalid communications rate; deviceResponse_:Lowpower
UART Wakeup
CONNECT 00800 bits/sec
2014-10-28T22:29:44.616Z,1414535384.616 [CBIT](CRITICAL): run-time exception #7
2014-10-28T22:29:44.616Z,1414535384.616 [CBIT](CRITICAL): Bad address: 0x40319008
2014-10-28T22:29:44.616Z,1414535384.616 [CBIT](CRITICAL): Backtrace: 
./bin/LRAUV(_ZN7PCaller20DefaultSignalHandlerEiP7siginfoPv+0x20) [0x16f2cc]
/lib/libc.so.6(__default_rt_sa_restorer+0) [0x40212510]

2014-10-28T22:29:45.155Z,1414535385.155 [CBIT](CRITICAL): run-time exception #7
2014-10-28T22:29:45.156Z,1414535385.156 [CBIT](CRITICAL): Bad address: 0x40319004
2014-10-28T22:29:45.156Z,1414535385.156 [CBIT](CRITICAL): Backtrace: 
./bin/LRAUV(_ZN7PCaller20DefaultSignalHandlerEiP7siginfoPv+0x20) [0x16f2cc]
/lib/libc.so.6(__default_rt_sa_restorer+0) [0x40212510]

2014-10-28T22:25:42.421Z,1414535142.421 [g3ESP](IMPORTANT): 
STATUS:Fixing 17.62ml Sample
2014-10-28T22:26:27.707Z,1414535187.707 [DVL_micro](FAULT): DVL failed to acquire valid data within timeout.
2014-10-28T22:26:28.628Z,1414535188.628 [DVL_micro](FAULT): LCB fault:  Software Overcurrent.
2014-10-28T22:26:32.273Z,1414535192.273 [MissionManager](IMPORTANT): Started mission Default
2014-10-28T22:27:50.600Z,1414535270.600 [BPC1](FAULT): Failed to parse bank B battery data
2014-10-28T22:28:22.361Z,1414535302.361 [Default:UpdateAndReportMinutesSinceMissionStarted:B](IMPORTANT): Default mission has been running for 1.828536 min 
2014-10-28T22:28:40.272Z,1414535320.272 [NAL9602](FAULT): MT Queue status failed to be acquired within timeout. Will not retry this session.
2014-10-28T22:29:33.800Z,1414535373.800 [DVL_micro](FAULT): DVL failed to acquire valid data within timeout.
2014-10-28T22:29:45.440Z,1414535385.440 [AHRS_sp3003D](FAULT): Read Heading/Pitch/Roll Failure.
2014-10-28T22:31:17.419Z,1414535477.419 [g3ESP](FAULT): Unknown response:
READY:to fix up to 1000ml with RNAlater