galene Path

trajectory

20230407T031936 [CommandExec]:got command restart logs

20230407T031955 [NAL9602]:Failed to initiate SBD session. Error code: 2

20230407T032015 [NAL9602]:Failed to initiate SBD session. Error code: 2

20230407T032038 [NAL9602]:Failed to initiate SBD session. Error code: 2

20230407T032650 [NAL9602]:MT Queue status failed to be acquired within timeout. Will not retry this session.

20230407T040321 [ThrusterHE]:Status lock Detected.

20230407T040322 [ThrusterHE]:Status lock Detected.

20230407T040323 [ThrusterHE]:Status lock Detected.

20230407T043317 [NAL9602]:MT Queue status failed to be acquired within timeout. Will not retry this session.

20230407T043428 [NAL9602]:Failed to receive proper response when querying signal strength for MT queue check.

20230407T043900 [NAL9602]:MT Queue status failed to be acquired within timeout. Will not retry this session.

20230407T050440 [CTD_Seabird]:Salinity reading out of range: 18.184006 psu

20230407T050508 [NAL9602]:Failed to receive proper response when querying signal strength for MT queue check.

20230407T051101 [NAL9602]:Failed to receive proper response when querying signal strength for MT queue check.

20230407T054639 [CommandExec]:got command schedule "load Science/sci2.tl;set sci2.MissionTimeout 16 h;set sci2.NeedCommsTime 30 min;set sci2.Repeat 2 count;set sci2.Lat1 36.725 degree;set sci2.Lon1 -121.85 degree;set sci2.Lat2 36.835 degree;set sci2.Lon2 -121.855 degree" 2sg1e 1 2.000000

20230407T054639 [CommandExec]:Scheduling command #1 of 2 with id=2sg1e

20230407T054639 [CommandExec]:Scheduled #19 (#1 of 2 with id='2sg1e'): "load Science/sci2.tl;set sci2.MissionTimeout 16 h;set sci2.NeedCommsTime 30 min;set sci2.Repeat 2 count;set sci2.Lat1 36.725 degree;set sci2.Lon1 -121.85 degree;set sci2.Lat2 36.835 degree;set sci2.Lon2 -121.855 degree", AFTER MISSION

20230407T054648 [CommandExec]:got command schedule "set sci2.Lat3 36.92 degree;set sci2.Lon3 -121.9 degree;set sci2.YoYoMaxDepth 15 m;set sci2.MaxDepth 22 m;run" 2sg1e 2 2.000000

20230407T054648 [CommandExec]:Scheduling command #2 of 2 with id=2sg1e

20230407T054648 [CommandExec]:Scheduled #20 (#2 of 2 with id='2sg1e'): "set sci2.Lat3 36.92 degree;set sci2.Lon3 -121.9 degree;set sci2.YoYoMaxDepth 15 m;set sci2.MaxDepth 22 m;run", AFTER MISSION

20230407T064521 [BPC1]:BPC1B: No match for serial number 1717 in BPC1B's battery stick inventory (sticks 32-62 in onboard configuration file).

20230407T082915 [CBIT]:Beginning ground fault scan

20230407T082918 [CBIT]:Error reading 24V bus power status. Assuming off for scan purposes.

20230407T111848 [BPC1]:BPC1B failed to parse battery data due to unrecognized msg size.

20230407T123049 [CTD_Seabird]:Failed to parse device response: 15.87,1#

20230407T131946 [CTD_Seabird]:Failed to parse device response: 5,3.73649,2820.88#

20230407T132949 [CTD_Seabird]:Failed to parse device response: 2765.25#

20230407T141119 [CTD_Seabird]:Salinity reading out of range: 26.511412 psu

20230407T141120 [CTD_Seabird]:Salinity reading out of range: 26.583004 psu

20230407T142927 [CBIT]:Beginning ground fault scan

20230407T142930 [CBIT]:Error reading 24V bus power status. Assuming off for scan purposes.

20230407T143852 [BPC1]:BPC1A: No match for serial number 1717 in BPC1A's battery stick inventory (sticks 1-31 in onboard configuration file).

20230407T151439 [NAL9602]:Inadequate Iridium signal strength reported: 0

20230407T151442 [NAL9602]:Inadequate Iridium signal strength reported: 0

20230407T151451 [NAL9602]:Inadequate Iridium signal strength reported: 0

20230407T152253 [sci2:NeedComms:D:A_Timeout:A]:Comms timed out after 30.000000 min minutes

20230407T192008 [ElevatorServo]:getPosition uart error serial timeout

20230407T192008 [ElevatorServo]:Elevator uart error - getPosition.serial timeout

20230407T192008 [ElevatorServo]:Communications Fault

20230407T192008 [CBIT]:Communications Fault in component: ElevatorServo

20230407T202939 [CBIT]:Beginning ground fault scan

20230407T202942 [CBIT]:Error reading 24V bus power status. Assuming off for scan purposes.

20230407T204857 [NAL9602]:Queried for signal strength and failed to receive proper response.

20230407T211534 [CTD_Seabird]:Failed to parse device response: .13#

20230407T212401 [BPC1]:BPC1B: No match for serial number 1717 in BPC1B's battery stick inventory (sticks 32-62 in onboard configuration file).

20230407T212548 [BPC1]:BPC1B failed to parse battery data due to unrecognized msg size.

20230407T220950 [NAL9602]:Queried for signal strength and failed to receive proper response.

20230407T222723 [BPC1]:BPC1B: No match for serial number 1717 in BPC1B's battery stick inventory (sticks 32-62 in onboard configuration file).

20230407T224702 [NAL9602]:Queried for signal strength and failed to receive proper response.

20230408T004704 [BuoyancyServo]:getPosition uart error serial timeout

20230408T004704 [BuoyancyServo]:Buoyancy getPosition uart error.serial timeout

20230408T004704 [BuoyancyServo]:Communications Fault

20230408T004704 [CBIT]:Communications Fault in component: BuoyancyServo

20230408T005435 [CTD_Seabird]:Failed to parse device response: .53#

20230408T013913 [ThrusterHE]:Could not get status:serial timeout

20230408T030302 [BPC1]:BPC1B failed to parse battery data due to unrecognized msg size.

20230408T040503 [BPC1]:BPC1A: No match for serial number 1717 in BPC1A's battery stick inventory (sticks 1-31 in onboard configuration file).

20230408T041041 [BPC1]:Battery stick #21 (s/n: 01DB) reported OVER_TEMP_ALARM. Status code: 0x1717.

20230408T043443 [CTD_Seabird]:Failed to parse device response: 78,4386.80#

20230408T052353 [NAL9602]:LCB fault: Invalid Command. Hardware Overcurrent Shutdown. Current Limiter Activated.

20230408T052353 [CBIT]:Hardware Fault in component: NAL9602

20230408T052506 [NAL9602]:parseGSV uart error: serial timeout

20230408T054142 [BPC1]:Failed to receive data from all sticks prior to timeout. Will not retry this scan cycle.

20230408T060650 [CommandExec]:got command stop

20230408T060650 [CommandExec]:Scheduling is paused for 2 commands

20230408T060651 [MissionManager]:Started mission Default

20230408T061314 [CommandExec]:got command schedule asap "load Science/sci2.tl;set sci2.MissionTimeout 24 h;set sci2.NeedCommsTime 60 min;set sci2.Repeat 2 count;set sci2.Lat1 36.725 degree;set sci2.Lon1 -121.85 degree;set sci2.Lat2 36.64501 degree;set sci2.Lon2 -122.01862 degree" 2ubxj 1 2.000000

20230408T061314 [CommandExec]:Scheduling command #1 of 2 with id=2ubxj

20230408T061314 [CommandExec]:Scheduled #21 (#1 of 2 with id='2ubxj'): "load Science/sci2.tl;set sci2.MissionTimeout 24 h;set sci2.NeedCommsTime 60 min;set sci2.Repeat 2 count;set sci2.Lat1 36.725 degree;set sci2.Lon1 -121.85 degree;set sci2.Lat2 36.64501 degree;set sci2.Lon2 -122.01862 degree", ASAP

20230408T061317 [Default:CheckIn:E]:Default mission has been running for 6.423452 min

20230408T061322 [CommandExec]:got command schedule asap "set sci2.Lat3 36.725 degree;set sci2.Lon3 -121.85 degree;set sci2.YoYoMaxDepth 30 m;set sci2.MaxDepth 35 m;run" 2ubxj 2 2.000000

20230408T061322 [CommandExec]:Scheduling command #2 of 2 with id=2ubxj

20230408T061322 [CommandExec]:Scheduled #22 (#2 of 2 with id='2ubxj'): "set sci2.Lat3 36.725 degree;set sci2.Lon3 -121.85 degree;set sci2.YoYoMaxDepth 30 m;set sci2.MaxDepth 35 m;run", ASAP

20230408T061322 [CommandExec]:got command load ./Missions/Science/sci2.tl

20230408T061322 [MissionManager]:Loading Compiled TethysL script from file ./Missions/Science/sci2.tx

20230408T061324 [CommandExec]:Loaded ./Missions/Science/sci2.tl

20230408T061335 [CommandExec]:got command set sci2.MissionTimeout 24 hour

20230408T061335 [CommandExec]:got command set sci2.NeedCommsTime 60 minute

20230408T061335 [CommandExec]:got command set sci2.Repeat 2 count

20230408T061335 [CommandExec]:got command set sci2.Lat1 36.725 degree

20230408T061335 [CommandExec]:got command set sci2.Lon1 -121.85 degree

20230408T061335 [CommandExec]:got command set sci2.Lat2 36.64501 degree

20230408T061335 [CommandExec]:got command set sci2.Lon2 -122.01862 degree

20230408T061341 [CommandExec]:got command set sci2.Lat3 36.725 degree

20230408T061341 [CommandExec]:got command set sci2.Lon3 -121.85 degree

20230408T061341 [CommandExec]:got command set sci2.YoYoMaxDepth 30 meter

20230408T061341 [CommandExec]:got command set sci2.MaxDepth 35 meter

20230408T061341 [CommandExec]:got command run

20230408T061341 [CommandExec]:Running

20230408T061341 [MissionManager]:Started mission sci2

20230408T061343 [sci2:M.AltitudeEnvelope]:Altitude Measurement is not Active.

20230408T061343 [sci2:StandardEnvelopes:A.AltitudeEnvelope]:Altitude Measurement is not Active.

20230408T061344 [CTD_Seabird]:Pressure reading out of range: -294.769989 decibar

20230408T062737 [CTD_Seabird]:Failed to parse device response: .44#

20230408T063459 [ElevatorServo]:getPosition uart error serial timeout

20230408T063459 [ElevatorServo]:Elevator uart error - getPosition.serial timeout

20230408T063459 [ElevatorServo]:Communications Fault

20230408T063459 [CBIT]:Communications Fault in component: ElevatorServo

20230408T064502 [BPC1]:BPC1A: No match for serial number FFFF in BPC1A's battery stick inventory (sticks 1-31 in onboard configuration file).

20230408T110026 [ElevatorServo]:getPosition uart error serial timeout

20230408T110026 [ElevatorServo]:Elevator uart error - getPosition.serial timeout

20230408T110026 [ElevatorServo]:Communications Fault

20230408T110027 [CBIT]:Communications Fault in component: ElevatorServo

20230408T133149 [BPC1]:BPC1A: No match for serial number 1717 in BPC1A's battery stick inventory (sticks 1-31 in onboard configuration file).